Sub-Zero Repair Pro Los Angeles · CA

Defrost circuit

EC 24: the defrost ran and the coil never got warm

Call it in Built-In 600-3 Series control

Read it out to us on (310) 844-1973

EC 24 is a defrost under-heat: the control started a defrost cycle on the freezer coil and did not see the coil reach the temperature that cycle is supposed to produce.

Hands at the open door of a dark undercounter unit with bare wooden shelves, the rear vent grille visible behind them and a small driver at the door frame
What the control is watching
The freezer evaporator during a defrost cycle — whether the coil actually warms up once the heater has been called for.
What makes it register
A defrost that finishes with the coil still cold. The heater circuit is reporting normally; the heat is not arriving.
Can you keep using it
For a day or two, yes, though the freezer will frost over progressively and the compartment will start losing ground. It does not fix itself.

Nothing about this code points at the compressor, and that is the useful part of it. The cold is being made; it is the twice-daily thaw that is failing, so ice accumulates on the coil until air can no longer pass through it. The compartment then gets warmer while the machine works harder, which is why the complaint that arrives is usually about temperature rather than about frost.

The order of testing follows the manufacturer’s own: heater resistance first, then whether the heater and the freezer evaporator thermistor are mounted where they belong, then the wiring between them and the control. Each step rules out a part rather than assuming one, which matters here because the three answers cost very different amounts.

Clearing the ice by hand will restore the freezer for a fortnight and change nothing. The code is worth acting on while it is still only a defrost fault.

What we usually find

  1. Ice rebuilding across the back wall within days of somebody clearing it, and this code on the panel

    The defrost heater itself, open circuit. It is the commonest single answer to this code and it is the first thing measured.

    Defrost heater, thermostat or sensor $280–$640

  2. A coil that partly clears — bare at the top, solid at the bottom

    A heater still working but not sitting where it should, or an evaporator thermistor that has been remounted out of position, so the heat and the sensor are in different places.

    Defrost heater, thermostat or sensor $280–$640

  3. The code returning a week after a heater was already replaced

    Connections rather than components — a terminal that looked fine cold and opens up warm. Worth ruling out before anybody talks about a board, which is why no band is put against it here.

    Quoted after the diagnosis

Which of these it is gets settled at the visit, before a part is ordered — Sub-Zero Repair Pro Los Angeles, (310) 844-1973.

Written by
Yuki Tanabe
Role
Refrigeration technician — controls and sensors
In the trade
18 years in the trade
Flexible door gasket lifted away from the corner of a refrigerator door liner

Book a visit

A Sub-Zero showing this in Los Angeles?

$89 service call, credited against the repair. Price agreed before anything is opened up. Visits 8:00 am – 8:00 pm, seven days; the line is answered 24/7.